最新の6006-1問題集で試験を準備する

Avaya 6006-1 試験概要:

Avaya 6006-1 試験シラバストピック:

Avaya Aura(TM) Communication Manager (R5.2.1) Implementation 認定 6006-1 試験問題：

1. Communication Manager does not appear to be running. A technician wants to verify that all of the applications have started and are up. There is no access through the system Management interface so logging into Linux is used to check this.
Which two Linux commands will give the output needed to verify this? (Choose two)

A) statserver
B) statapp
C) systat
D) statuslicense

2. Which hardware is required to implement Avaya IP Softphone in the telecommuter mode?

A) media processor board
B) CLAN board
C) digital circuit board
D) DS 1 board

3. A customer uses a S8510 server with a Media Gateway G650. No more circuit pack slots are left and the customer has already ordered and received the necessary components for adding additional DCP phones to the system, including a new G850.
Which three tasks need to be performed while installing the additional equipment?
(Choose three)

A) Add additional 2GB of RAM to the S8510 server.
B) Set the proper carrier address ID for the second G650 carrier.
C) Cable the two G850 carries with a TDM/LAN Bus Extender cable.
D) The new digital line card must be installed din slot 2 of new G650
E) Remove the right TDM/LAN bus terminal from the bottom G850 carrier and install the bus terminator at the left end of the TDM/LAN bus on the G650 carrier directly above.

4. In addition to the duplicated servers, which other component should be duplicated in a high reliability S8xxx series Server configuration?

A) SIPI
B) IPSI
C) Media Resource
D) CLAN
E) Media Processor

5. What are two ways of obtaining the RFA Module ID (MID) and System ID (SID)?
(Choose two.)

A) From the CM SAT issue the command list configuration software-versions.
B) From the CM Linux prompt issue the command 'systat'.
C) From the CM SAT issue the command 'display system-parameters customer-options.
D) From the CM Linux prompt issue the command "statuslicense -V.

質問と回答：