最新のNCM-MCI5.15問題集で試験を準備する

Nutanix NCM-MCI5.15 試験概要:

Nutanix NCM-MCI5.15 試験シラバストピック:

Nutanix Certified Master - Multicloud Infrastructure (NCM-MCI-5.15) 認定 NCM-MCI5.15 試験問題：

問題 #1

A new Nutanix cluster is ready for production on a remote site with no IT staff. Changes to the infrastructure will cost money and probably cause a cluster stop. The administrator needs to perform a health check on the environment that should include:
* Network connectivity checks
* Network performance status
* Storage performance status
Which tool should be used to perform this test?

A. NCC
B. clurator_cli
C. X-Ray
D. diagnostic, py

問題 #2

An administrator is using Nutanix Move to migrate a Windows VM from ESXi to AHV. Automated guest preparation is failing with an error:
Account has UAC enabled error
The administrator is using the local built-in administrator account for the Windows VM Admin approval mode must remain enabled.
What should the administrator do to continue with the migration with Nutanix Move?

A. Follow manual VM preparation guidelines
B. Place Windows VM in Maintenance Mode
C. Use a Domain Admin account for the Windows VM
D. Reboot the Windows VM and try the migration again

問題 #3

A customer has NearSync configured. When the administrator tries to restore a snapshot from 3 minutes ago, it is not available. The snapshots are happening at 15-minute intervals instead of at the 5-minute configured interval. When the protection domain was initially set up, the snapshots were happening at the expected 5-minute interval.
What should the customer do to enable the snapshots to happen at the expected interval?

A. Utilize Metro Availability to meet this requirement
B. Change the protection domain to use Async DR
C. Configure the protection domain to take snapshots on 15-minute intervals
D. Fix a connectivity issue because the protection domain reverted to Async

問題 #4

Refer to the exhibit.

A Nutanix host is connected as shown in the exhibit with br0-up set to active/backup. Physical Switch 1 experiences a power outage causing br0-up to failover to using eth2. The CVM and host become inaccessible. User VMs restart on other hosts in the cluster, which causes a disruption to those VMs.
Which configuration issue likely caused this outage?

A. Bridge br0-up should be configured to use balance-tcp rather than active/backup.
B. The user VMs only have one NIC
C. The CVM should have eth1 connected to the OVS.
D. The upstream port for eth2 is missing a VLAN.

問題 #5

An administrator deploys Exchange on a Nutanix cluster. The administrator creates two containers with RF2 configuration:
* One container for Exchange
* One container for the other VMs
The Exchange VM is experiencing I/O performance issues.
Which changes to Storage Optimization should be used on the Exchange container to enhance I/O performance?

A. No data reduction
B. Inline compression and Deduplication
C. Post process Deduplication only
D. Inline compression and EC-X

解説：