最新のH12-261-ENU問題集で試験を準備する

Huawei H12-261-ENU 試験概要:

Huawei H12-261-ENU 試験シラバストピック:

Huawei HCIE-Routing&Switching (Written)(Huawei Certified ICT Expert-Routing & Switching) 認定 H12-261-ENU 試験問題：

問題 #1

To view the routing table of router R1, execute the command "display ip routing-table" on the route R1. Router R1 runs OSPF. Which of the following is true about the OSPF information in the routing table?

A. In the routing table, the routing entry identified by the "O_IA" identifier is the intraregional routing.
B. In the routing table, the routing entry identified by the "O_ASE" identifier indicates that the entry was learned through a Type 1 LSA or a Type 2 LSA.
C. In the routing table, the routing entry identified by the "OSPF" identifier are learned through the Type 7 LSA imported from other processes to OSPF.
D. In the routing table, the routing entry identified by the "O_ASE" identifier indicates that the entry can only be learned through routing.
E. In the routing table, all types of LSAs correspond to unique destination addresses.

問題 #2

Regarding route introduction, which of the following description is wrong?

A. bgp supports both import and network when generating routes. Network mode is more accurate.
B. After the ISIS level-2 network route is imported to the level-1 route, the routing loop is formed if the import policy is not manually configured.
C. Introducing IBGP routes in OSPF may cause routing loops.
D. By default, the default metric of the external route redistributed by OSPF is 1, and the imported external route type is Type2.

問題 #3

The following procedure for NDP to resolve the link layer address is correct or not.

A. True
B. False

問題 #4

In the lab network, the network is built as follows. SW1 is the default configuration and SW2 disables STP. Which of the following description about the scenario is correct?

A. G0/0/2 of sw2 enters Discarding state
B. No interface is blocked
C. G0/0/1 of sw2 enters Discarding state
D. G0/0/2 of Sw1 enters Discarding state
E. G0/0/1 of SW1 enters Discarding state.

問題 #5

If the PPP link between R1 and R2 is shown, and the direct connection port is not on the same network segment, but the R1 and R2 direct connection ports can communicate, and the Ethernet link cannot communicate under the same IP planning, what is the reason? (Multiple choice)

A. R1 and R2 are connected to the POS port, and the 24-bit subnet route of the direct connection port of the other party is learned through IPCP.
B. R1 and R2 are connected to the POS port, and the 32-bit host route of the direct connection port of the other party is learned through IPCP.
C. The data packets of the interconnected POS interface of R1 and R2 do not need to encapsulate the Ethernet header, and do not need to use ARP to request the MAC address.
D. The interconnected POS port of R1 and R2 learns the MAC address of the peer interface through LCP, and does not require the ARP request MAC address.

解説：