最新のCWDP-304問題集で試験を準備する

When performing a spectrum analysis walkthrough of a facility tor which you will be creating a WLAN design you detect an interferer What should you do?

• A. Locate and remove the interferer immediately so that your WLAN works well
• B. Make note of it using the reporting features of your spectrum analyzer or by documenting it elsewhere
• C. Make a mental note of it so that you can include it in your design
• D. Walk away from the project because it is best to only deploy in clean environments with no other RF signals

What commonly causes a client-to-AP link imbalance?

• A. The AP's antenna gain is lower than the client's antenna gain
• B. The client's transmit power is significantly lower than the AP's transmit power
• C. The AP's transmit power is significantly lower than the client's transmit power
• D. The client's antenna gain is lower than the AP's antenna gain

What is the minimum PoE budget needed on a switch to support 6 (six) APs that can only be powered using IEEE 802.3at if no other details are provided?

• A. 180 W
• B. 60 W
• C. 240 W
• D. 320 W

What roaming technology uses stored keys at the APs for roam back if a client STA returns after having roamed away?
Response:

• A. PMK caching
• B. Preauthentication
• C. SCA roaming
• D. OKC

You ate evaluating CO impact in 2 4 GHz. During the post-validation survey, you determine that 2 or 3 APs are seen from every location in the 2 4 GHz band with signal strengths above -75 dBm from all seen Aps.
Does this show that CO has been removed from the environment given that three non-overlapping channels exist in 2.4 GHz and why?

• A. Yes because you would see 3 APs m every location with a signal strength above -75 dBm if CO exists
• B. Yes, because the goal is to see only l AP at each location in 2 4 GHz
• C. No, because CCI can exist even with signals as low as -85 dBm to -93 dBm
• D. No, because the goal is to see only 1 AP at each location in 2 4 GHz